Cisco Catalyst 4500 Series Software Configuration Manual page 1919

Chapter 77 Configuring Call Home
To subscribe a destination profile to an alert group, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# call-home
Step 3
Switch(cfg-call-home)# alert-group
{all|configuration|diagnostic|
environment|inventory|syslog}
Step 4
Switch(cfg-call-home)# profile name
Step 5
Switch(cfg-call-home-profile)#
subscribe-to-alert-group configuration
[periodic {daily hh:mm | monthly date hh:mm |
weekly day hh:mm}]
Switch(cfg-call-home-profile)#
subscribe-to-alert-group all
Step 6
Switch(cfg-call-home-profile)#
subscribe-to-alert-group diagnostic
[severity catastrophic|disaster|
fatal|critical|major|minor|warning|
notification|normal|debugging]
Step 7
Switch(cfg-call-home-profile)#
subscribe-to-alert-group environment
[severity catastrophic|disaster|
fatal|critical|major|minor|warning|
notification|normal|debugging]
Step 8
Switch(cfg-call-home-profile)#
subscribe-to-alert-group inventory
[periodic {daily hh:mm | monthly date hh:mm |
weekly day hh:mm}]
Step 9
Switch(cfg-call-home-profile)#
subscribe-to-alert-group syslog
[severity catastrophic|disaster|
fatal|critical|major|minor|warning|
notification|normal|debugging]
[pattern string]
Step 10
Switch(cfg-call-home-profile)# exit
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Purpose
Enters configuration mode.
Enters Call Home configuration submode.
Enables the specified alert group. Use the
keyword all to enable all alert groups. By
default, all alert groups are enabled.
Enters the Call Home destination profile
configuration submode for the specified
destination profile.
Subscribes this destination profile to the
Configuration alert group. The Configuration
alert group can be configured for periodic
notification, as described in the
Periodic Notification" section on page
Subscribes to all available alert groups.
Subscribes this destination profile to the
Diagnostic alert group. The Diagnostic alert
group can be configured to filter messages based
on severity, as described in the
Message Severity Threshold" section on
page 77-8.
Subscribes this destination profile to the
Environment alert group. The Environment alert
group can be configured to filter messages based
on severity, as described in the
Message Severity Threshold" section on
page 77-8.
Subscribes this destination profile to the
Inventory alert group. The Inventory alert group
can be configured for periodic notification, as
described in the "Configuring Periodic
Notification" section on page
Subscribes this destination profile to the Syslog
alert group. The Syslog alert group can be
configured to filter messages based on severity,
as described in the "Configuring Message
Severity Threshold" section on page
can specify a pattern to be matched in the syslog
message. If the pattern contains spaces, you
must enclose it in quotes ("").
Exits the Call Home destination profile
configuration submode.
Configuring Call Home
"Configuring
77-8.
"Configuring
"Configuring
77-8.
77-8. You
77-7