Configuring Static Route With The Next-Hop Dynamically Obtained Through Dhcp - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 59 Configuring the Cisco IOS DHCP Server
Step 5
Switch(dhcp-config)# class class-name
Switch(dhcp-pool-class)# address range
Step 6
start-ip end-ip
Step 7 Repeat Steps 5 and 6 for each DHCP class you
need to associate with the DHCP pool.
Switch(dhcp-pool-class)# end
Step 8
Configuring Static Route with the Next-Hop Dynamically Obtained Through
DHCP
This task enables static routes to be assigned using a DHCP default gateway as the next-hop device.
Without this feature the gateway IP address is not known until after the DHCP address assignment. You
cannot configure a static route with the CLI without knowing that DHCP-supplied address.
Before You Begin
Verify all DHCP client and server configuration steps. Ensure that the DHCP client and server are
properly defined to supply a DHCP device option 3 of the DHCP packet.
Step 1
Switch> enable
Step 2
Switch# configure terminal
Step 3
Switch(config)# ip route prefix mask
{ip-address | interface-type
interface-number [ip-address]} dhcp
[distance]
Switch(config)# end
Step 4
Switch# show ip route
Step 5
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Associates a class with a pool and enters DHCP pool class
configuration mode.
This command also creates a DHCP class if the DHCP class
•
is not yet defined.
(Optional) Sets an address range for the DHCP class in a DHCP
server address pool.
If this command is not configured for a class, the default
•
value is the entire subnet of the pool. Each class in the DHCP
pool is examined for a match in the order configured.
—
Exits DHCP pool class option mode and returns to privileged
EXEC mode.
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Assigns a static route for the default next-hop device when the
DHCP server is accessed for an IP address.
If more than one interface is configured to obtain an IP
•
address from a DHCP server, use the ip route prefix mask
interface-type interface-number dhcp command for each
interface. If the interface is not specified, the route is added
to the routing table as soon as any of the interfaces obtain an
IP address and a default device.
Exits global configuration mode and returns to privileged EXEC
mode.
(Optional) Displays the current state of the routing table.
Configuring DHCP Address Pools
59-23