Cisco Catalyst 4500 Series Software Configuration Manual page 1133

Chapter 44 Configuring Quality of Service
ip access-list 103 permit ip any any
Class-map match-all RT
match ip access-group 101
Class-map Match all PD
match ip access-group 103
Policy-map P31_QoS
Class RT
Police 200m 16k conform transmit exceed drop
Class PD
Police 100m 16k conform transmit exceed drop
Interface Gigabit 3/1
Switchport
Switchport trunk encapsulation dot1q
Switchport trunk allowed vlan 101-102
Example 2
Let us assume that interface Gigabit Ethernet 6/1 is a trunk port and belongs to VLANs 20, 300-301, and
400. The following example shows how to apply policy-map p1 for traffic in VLANs 20 and 400 and
policy map p2 to traffic in VLANs 300 through 301:
Switch# configure terminal
Switch(config)# interface gigabitethernet 6/1
Switch(config-if)# vlan-range 20,400
Switch(config-if-vlan-range)# service-policy input p1
Switch(config-if-vlan-range)# exit
Switch(config-if)# vlan-range 300-301
Switch(config-if-vlan-range)# service-policy output p2
Switch(config-if-vlan-range)# end
Switch#
Example 3
The following command shows how to display policy-map statistics on VLAN 20 configured on Gigabit
Ethernet interface 6/1:
Switch# show policy-map interface gigabitEthernet 6/1 vlan 20
GigabitEthernet6/1 vlan 20
Service-policy input: p1
Vlan range 101
Service-policy input P31_QoS
Service-policy output P31_QoS
Vlan range 102
Service-policy input P32_QoS
Service-policy output P32_QoS
Class-map: c1 (match-all)
0 packets
Match: cos 1
Match: access-group 100
police:
cir 100000000 bps, bc 3125000 bytes
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Configuring VSS QoS
44-37