Configuration Examples For The Database Agent - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 60 Configuring DHCP Snooping, IP Source Guard, and IPSG for Static Hosts
SwitchB# show errdisable recovery
ErrDisable Reason
-----------------
udld
bpduguard
security-violatio
channel-misconfig
vmps
pagp-flap
dtp-flap
link-flap
l2ptguard
psecure-violation
gbic-invalid
dhcp-rate-limit
unicast-flood
storm-control
arp-inspection
Timer interval: 300 seconds
Interfaces that will be enabled at the next timeout:
SwitchB#
1w2d: %SW_DAI-4-PACKET_RATE_EXCEEDED: 101 packets received in 739 milliseconds on Gi3/31.
1w2d: %PM-4-ERR_DISABLE: arp-inspection error detected on Gi3/31, putting Gi3/31 in
err-disable state
SwitchB# show clock
*02:21:43.556 UTC Fri Feb 4 2005
SwitchB#
SwitchB# show interface g3/31 status
Port
Gi3/31
SwitchB#
SwitchB#
1w2d: %PM-4-ERR_RECOVER: Attempting to recover from arp-inspection err-disable state on
Gi3/31
SwitchB# show interface g3/31 status
Port
Gi3/31
SwitchB# show clock
*02:27:40.336 UTC Fri Feb 4 2005
SwitchB#

Configuration Examples for the Database Agent

The following examples show how to configuration commands in the previous procedure:
Example 1: Enabling the Database Agent
The following example shows how to configure the DHCP snooping database agent to store the bindings
at a given location and to view the configuration and operating state:
Switch# configure terminal
Switch(config)# ip dhcp snooping database tftp://10.1.1.1/directory/file
Switch(config)# end
Timer Status
--------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Enabled
Name
Name
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Status Vlan
err-disabled 100
Status Vlan
connected 100
Configuring DHCP Snooping
Duplex Speed Type
auto auto 10/100/1000-TX
Duplex Speed Type
a-full a-100 10/100/1000-TX
60-15