Obtain Nw User Property - Kyocera ECOSYS P8060cdn Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Obtain NW User Property

Set the required information to obtain the network user property from the LDAP server. The user name and E-mail
address obtained with this setting is shown in the user information, the status confirmation screen, and the header of
E-mail.
NOTE
To obtain the network user property from the LDAP server, User Login Administration must be enabled in "Enabling
User Login Administration".
Select "On" for "LDAP" in "Protocol Detail".
Enabling User Login Administration (page 9-3)
Protocol Settings (page 8-38)
1
2
Display the screen.
1
[System Menu/Counter] key > [User Login/Job Accounting]
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login with administrator
privileges.
The factory default login user name and login password are set as shown below.
Login User Name: 6000
Login Password: 6000
2
[User Login Setting] > [Obtain NW User Property] > [On]
Configure the settings.
[On] > Add information on each item > [OK]
Item
*1
Server Name
Port
*2
Name 1
*3
Name 2
*4
E-mail Address
*5
Authentic at Type
Enter the LDAP server name or the IP address (up to 64
characters). If a server name is not entered, user
information will be acquired from the server set for Network
Authentication.
Port number for LDAP server. The default port number is
389.
Enter the LDAP Attribute to obtain the user name to be
displayed from the LDAP server (up to 32 characters).
Enter the LDAP Attribute to obtain the user name to be
displayed from the LDAP server (up to 32 characters).
Enter the LDAP Attribute to obtain the E-mail address from
the LDAP server (up to 32 characters).
Set the authentication method. Select [Simple] or [SASL].
After changing the setting, restart the system or turn the
power off and then on.
9-13
Descriptions