Kyocera ECOSYS P8060cdn Operation Manual page 336

Troubleshooting > Troubleshooting
Message
Cannot print the
specified number of
*1
copies.
Cannot process this
*1
job.
Cannot punch at the
specified position.
Cannot punch this
paper.
Cannot read data in
this ID card.
Cannot recognize.
Cannot staple at the
specified position.
Cannot staple this
*1
paper.
Cannot use ##### due
to a failure.
Checkpoints
—
―
―
Have you selected a position
that cannot be punched?
Did you select a paper size/type
that cannot be punched?
―
―
Have you selected a position
that cannot be stapled?
Did you select a paper size/type
that cannot be stapled?
―
10-25
Corrective Actions
Only one copy is available.
Select [Continue] to continue
printing. Select [Cancel] to
cancel the job.
Restricted by Authorization
settings. The job is canceled.
Select [End].
Restricted by Job Accounting.
The job is canceled. Select
[End].
If the selected paper is not
changed and [Continue] is
selected, punch is released.
Select the available paper.
Select [Continue] to print.
If the selected paper is not
changed and [Continue] is
selected, punch is released.
Select the available paper.
Select [Continue] to print.
In registration process, the ID
card information was not read
correctly. Hold again the ID card
over the ID card reading part.
If the same message still
appears, the ID card may not be
compatible with this product.
Change it to another ID card.
Make sure your ID card has
been registered.
If the selected paper is not
changed and [Continue] is
selected, staple is released.
Select the available paper.
Select [Continue] to print.
If the selected paper is not
changed and [Continue] is
selected, staple is released.
Select the available paper.
Select [Continue] to print.
Call service.
Reference
Page
—
―
page 9-21
page 6-11
page 6-11
―
―
page 6-9
page 6-9
―