Motorola APX 1000 Basic Service Manual page 52

5-4
Name of Display
FLASHcode
RF band 1
Tuning Ver
Proc Ver
Option Board
Type
Option Board
Serial Number
Option Board
Bluetooth Addr
Option Board
Sw Version
Exp Board Type
NOTE: All displays are temporary and will expire without any user intervention. If information is
longer than the physical length of the radio's display, the information will wrap around to
the next display. After the last display, "RF TEST" is displayed.
To freeze any of the displays, press the left arrow on the 4-Way Navigation Button. To
resume automatic scrolling, press the right arrow on the 4-Way Navigation Button. To
rapidly scroll forward through the displays, continue pressing the right arrow. You cannot
scroll backwards.
NOTE: Press the Top Side Button (Purple button) to advance the test environments from "RF
TEST", "CH TEST", "RGB TEST" then press the
Top Button (Orange button) to confirm selection. Press any other buttons to advance the
test.
Once a test is carried out, restart the radio to proceed to another test.
3. Do one of the following:
• Press the Top Side Button to stop the displays and toggle between RF test mode and the
Control Top and Keypad test mode. The test mode menu "CH TEST" is displayed,
indicating that you have selected the Control Top and Keypad test mode. Go to Section
"5.2.3 Control Top and Keypad Test Mode" on page
NOTE: Each press of the Top Side Button (Purple button) scrolls through "RF TEST",
• Press the Top Button (Orange button) to stop the displays and put the radio into the RF
test mode. The test mode menu, "1 CSQ", is displayed, indicating test frequency 1, Carrier
SQuelch mode. Go to Section
NOTE: Once your radio is in a particular test mode, you must turn off the radio and turn it
Table 5-2. Test-Mode Displays (Continued)
Description
The FLASH codes as programmed in the
codeplug
The radio's operating frequency
Version of Tuning codeplug
Version of Processor
Type of Keypad board being used
Serial number of the Keypad board is
displayed
Bluetooth Address of the Keypad board is
displayed
Software version of the Keypad Board is
displayed
Type of Keypad Board is displayed
"CH TEST" and "RGB TEST".
back on again to access the other test mode.
Performance Checks: Display Radio Test Mode
Always
Always
Always
Always
When the radio has an Option
Board/Expanded Keypad Board.
When the radio has an
Expanded Keypad Board.
When the radio has an
Expanded Keypad Board.
When the radio has an
Expanded Keypad Board.
When the radio has a Keypad
Board.
1:5-7.
"5.2.2 RF Test Mode" below.
Appears