Motorola APX 1000 Basic Service Manual page 231

Disassembly/Reassembly Procedures: Radio Reassembly
7.6.4 Reassemble the Main Board (16)
1. Plug in the connectors from the Keypad Flex (11) and the Front Kit Flex onto the Main Board
(16). With both the flexes connected to the Main Board, place the Main Board into the
Chassis (25) as shown in
.
NOTE: Plug in the connectors at the side of the Keypad Flex which reads "To Main Board". Ensure
that the Battery Contact Seal (28) does not pinch and the tabs of the Main O-Ring are held in
place when assembling the Main Board onto the Chassis.
2. With the Main Board (16) seated in the Chassis (25), gently assemble the Main O-Ring (24)
to the Antenna Holder as shown in
.
Figure 7-30.
Keypad Flex
Front Kit Flex
Figure 7-30. Assemble the RF Board
Figure 7-31. Assemble the Main O-Ring at Antenna Holder
Figure 7-31.
7-23