Motorola APX 1000 Basic Service Manual page 464

8-30
8.6.5 Reassemble the Keypad Retainer (34)
1. Place the Keypad Retainer (34) over the Keypad Board (35) in the Front Housing (19) as
shown in
2. Torque all four keypad retainer screws (33) with a Torx IP6 Bit and a Torque Driver to 1.2 in-lbf
in the sequence as shown in
Figure 8-40.
Figure 8-40. Place Keypad Retainer over the Keypad Board
Figure 8-41.
Figure 8-41. Torque in the Keypad Retainer Screws
Disassembly/Reassembly Procedures: Radio Reassembly
4
2
1
3