Motorola APX 1000 Basic Service Manual page 452

8-18
8.5.2 Servicing Chassis Assembly
Microphone Boot
Back Mic Flex
Backer
Main O Ring
8.5.2.1 Servicing Ventilation Label:
1. Complete steps in
2. Carefully peel off the label.
3. Use the Black Stick to help remove any difficult sections of the label.
4. Clean the area once the label is removed to ensure it is free from adhesive and debris.
5. Peel the new label off its backer and place in the respective location.
6. Apply slight pressure for 10 seconds to set the adhesive.
!
a u t i o n
Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
Figure 8-26. Serviceable Components – Chassis Assembly
Section 8.4.
Ventilation label should always be replaced when back kit
assembly is removed.
Microphone Membrane
Vacuum Port Seal
Battery Connector
Seal
Ventilation Label