Configuring Common Ipv6 Pim Timers - HP 6125XLG Ip Multicast Configuration Manual

Step
7. Enable the neighbor tracking
function.
Configuring hello message options on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Set the DR priority.
4. Set the neighbor lifetime.
5. Set the IPv6 PIM message
propagation delay.
6. Set the override interval.
7. Enable the neighbor tracking
function.
8. Enable dropping hello
messages without the
Generation ID option.

Configuring common IPv6 PIM timers

CAUTION:
To prevent the upstream neighbors from aging out, you must configure the interval for sending join/prune
messages less than the joined/pruned state holdtime timer.
IPv6 PIM routers periodically send hello messages to discover IPv6 PIM neighbors, and maintain IPv6
PIM neighbor relationship.
After receiving a hello message, an IPv6 PIM router waits for a random time period before sending a
hello message. This random time period is smaller than the maximum delay for sending hello messages.
It is used to avoid collisions when multiple IPv6 PIM routers send hello messages simultaneously.
An IPv6 PIM router periodically sends join/prune messages to its upstream routers for state update. A
join/prune message contains the joined/pruned state timeout value. This value is used by an upstream
router to determine how long it will keep the joined state or pruned state for the downstream interfaces.
When a router fails to receive subsequent IPv6 multicast data from the IPv6 multicast source S, the router
does not immediately remove the associated (S, G) entry. Instead, it maintains the (S, G) entry for a
period of time (namely, the IPv6 multicast source lifetime) before deleting the (S, G) entry.
You can configure common IPv6 PIM timers in IPv6 PIM view or interface view. The configurations made
in IPv6 PIM view are effective on all interfaces and the configurations made in interface view are effective
Command
hello-option neighbor-tracking
Command
system-view
interface interface-type
interface-number
ipv6 pim hello-option dr-priority
priority
ipv6 pim hello-option holdtime
time
ipv6 pim hello-option lan-delay
delay
ipv6 pim hello-option
override-interval interval
ipv6 pim hello-option
neighbor-tracking
ipv6 pim require-genid
307
Remarks
By default, the neighbor tracking
function is disabled.
Remarks
N/A
N/A
By default, the DR priority is 1.
By default, the neighbor lifetime is
105 seconds.
By default, the IPv6 PIM message
propagation delay is 500
milliseconds.
By default, the override interval is
2500 milliseconds.
By default, the neighbor tracking
function is disabled.
By default, an interface accepts
hello message without the
Generation ID option.