HP 6125XLG Ip Multicast Configuration Manual page 274

Joining an IPv6 multicast group
Figure 82 MLD queries and reports
Router A
Ethernet
Host A
(G2)
As shown in
to IPv6 multicast group G1. Host A wants to receive the IPv6 multicast data addressed to G2. The
following process describes how the hosts join the IPv6 multicast groups and how the MLD querier (Router
B in Figure 82) maintains the IPv6 multicast group memberships:
1. The hosts send unsolicited MLD reports to the IPv6 multicast groups they want to join without having
to wait for the MLD queries from the MLD querier.
2. The MLD querier periodically multicasts MLD queries (with the destination address FF02::1) to all
hosts and routers on the local subnet.
3. After receiving a query, Host B or Host C (the delay timer of whichever expires first) sends an MLD
report to the IPv6 multicast group G1 to announce its membership for G1. Assume that Host B
sends the report. After hearing the report from Host B, Host C, which is on the same subnet as Host
B, suppresses its own report for G1. Because MLD routers (Router A and Router B) already know
that G1 has at least one member, other members do not need to report their memberships. This
mechanism, known as the "MLD report suppression," helps reduce traffic on the local subnet.
4. At the same time, because Host A is interested in G2, it sends a report to the IPv6 multicast group
G2.
5. Through the query/report process, the MLD routers learn that G1 and G2 have members on the
local subnet. The IPv6 multicast routing protocol (for example, IPv6 PIM) that is running on the
routers generates (*, G1) and (*, G2) multicast forwarding entries. These entries are the basis for
subsequent IPv6 multicast forwarding. The asterisk (*) represents any IPv6 multicast source.
6. When the IPv6 multicast data addressed to G1 or G2 reaches an MLD router, the router looks up
the IPv6 multicast forwarding table. Based on the (*, G1) and (*, G2) entries, the router forwards
the IPv6 multicast data to the local subnet. Then, the receivers on the subnet receive the data.
Leaving an IPv6 multicast group
When a host leaves a multicast group, the following process occurs:
IPv6 network
Host B
(G1)
Query
Report
Figure 82, assume that Host B and Host C want to receive the IPv6 multicast data addressed
Querier
Router B
Host C
(G1)
264