[Routera-Mrib] Quit; Enable Igmp On Ten-Gigabitethernet; [Routera] Interface Ten-Gigabitethernet 1/1/5; [Routera-Ten-Gigabitethernet1/1/5] Quit - HP 6125XLG Ip Multicast Configuration Manual

Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Configure OSPF on the routers to make sure the following conditions are met: (Details not shown.)
The routers are interoperable at the network layer.
The routers can dynamically update their routing information.
3. Configure Router A:
# Enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing

[RouterA-mrib] quit

# Enable PIM-SM on each interface.

[RouterA] interface ten-gigabitethernet 1/1/5

[RouterA-Ten-GigabitEthernet1/1/5] pim sm

[RouterA-Ten-GigabitEthernet1/1/5] quit

[RouterA] interface ten-gigabitethernet 1/1/6
[RouterA-Ten-GigabitEthernet1/1/6] pim sm

[RouterA-Ten-GigabitEthernet1/1/6] quit

# Configure Ten-GigabitEthernet 1/1/6 as a C-BSR and C-RP.
[RouterA] pim
[RouterA-pim] c-bsr 10.1.1.1
[RouterA-pim] c-rp 10.1.1.1
[RouterA-pim] quit
4. Configure Router B:
# Enable IP multicast routing.
<RouterB> system-view
[RouterB] multicast routing
[RouterB-mrib] quit
# Enable PIM-SM on each interface.
[RouterB] interface ten-gigabitethernet 1/1/5
[RouterB-Ten-GigabitEthernet1/1/5] pim sm
[RouterB-Ten-GigabitEthernet1/1/5] quit
[RouterB] interface ten-gigabitethernet 1/1/6
[RouterB-Ten-GigabitEthernet1/1/6] pim sm
[RouterB-Ten-GigabitEthernet1/1/6] quit
5. Configure Router C:
# Enable IP multicast routing.
<RouterC> system-view
[RouterC] multicast routing
[RouterC-mrib] quit

# Enable IGMP on Ten-GigabitEthernet 1/1/5.

[RouterC] interface ten-gigabitethernet 1/1/5
[RouterC-Ten-GigabitEthernet1/1/5] igmp enable
[RouterC-Ten-GigabitEthernet1/1/5] quit
# Enable PIM-SM on Ten-GigabitEthernet 1/1/6.
37
Figure 16. (Details not