HP 6125XLG Ip Multicast Configuration Manual page 318

on only the current interface. If you configure hello message options in both IPv6 PIM view and interface
view, the configuration in interface view always takes precedence.
TIP:
For a network without special requirements, HP recommends using the defaults.
Configuring common IPv6 PIM timers globally
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Set the interval to send hello
messages.
4. Set the interval to send
join/prune messages.
5. Set the joined/pruned state
holdtime timer.
6. Set the IPv6 multicast source
lifetime.
Configuring common IPv6 PIM timers on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Set the interval to send hello
messages.
4. Set the maximum delay for
sending hello messages.
5. Set the interval to send
join/prune messages.
6. Set the joined/pruned state
holdtime timer.
Command
system-view
ipv6 pim [ vpn-instance
vpn-instance-name ]
timer hello interval
timer join-prune interval
holdtime join-prune time
source-lifetime time
Command
system-view
interface interface-type
interface-number
ipv6 pim timer hello interval
ipv6 pim triggered-hello-delay
delay
ipv6 pim timer join-prune interval
ipv6 pim holdtime join-prune time
308
Remarks
N/A
N/A
By default, the interval to send
hello messages is 30 seconds.
By default, the interval to send
join/prune messages is 60
seconds.
NOTE:
This configuration takes effect after
the current interval ends.
By default, the joined/pruned state
holdtime timer is 210 seconds.
By default, the IPv6 multicast
source lifetime is 210 seconds.
Remarks
N/A
N/A
By default, the interval to send
hello messages is 30 seconds.
By default, the maximum delay for
sending hello messages is 5
seconds.
By default, the interval to send
join/prune messages is 60
seconds.
NOTE:
This configuration takes effect after
the current interval ends.
By default, the joined/pruned state
holdtime timer is 210 seconds.