Ipv6 Bidir-Pim Overview - HP 6125XLG Ip Multicast Configuration Manual

To eliminate these weaknesses, IPv6 PIM-SM allows an RP or the receiver-side DR to initiate a switchover
to SPT:
The RP initiates a switchover to SPT:
•
After receiving the first (S, G) multicast packet, the RP immediately sends an (S, G) source-specific
join message toward the IPv6 multicast source. The routers along the path from the RP to the IPv6
multicast source constitute an SPT branch. The subsequent IPv6 multicast data for the IPv6 multicast
group is forwarded to the RP along the SPT without being encapsulated in register messages.
For more information about the switchover to SPT initiated by the RP, see
registration."
• The receiver-side DR initiates a switchover to SPT:
After receiving the first (S, G) multicast packet, the receiver-side DR immediately initiates a
switchover to SPT, as follows:
a. The receiver-side DR sends an (S, G) source-specific join message toward the IPv6 multicast
source. The routers along the path from the RP to the IPv6 multicast source create an (S, G) entry
in their forwarding table to constitute an SPT branch.
b. When the multicast packets reach the router where the RPT and the SPT branches, the router
drops the multicast packets that travel along the RPT. It also sends a prune message with the RP
bit to the RP.
c. After receiving the prune message, the RP forwards it toward the IPv6 multicast source
(supposed only one receiver exists). Thus, the switchover to SPT is completed. The subsequent
IPv6 multicast packets travel along the SPT from the IPv6 multicast source to the receiver hosts.
With the switchover to SPT, IPv6 PIM-SM builds SPTs more economically than IPv6 PIM-DM does.
Assert
IPv6 PIM-SM uses a similar assert mechanism as IPv6 PIM-DM does. For more information, see "Assert."

IPv6 BIDIR-PIM overview

In some many-to-many applications, such as a multi-side video conference, multiple receivers might be
interested in the IPv6 multicast data from multiple IPv6 multicast sources. With IPv6 PIM-DM or IPv6
PIM-SM, each router along the SPT must create an (S, G) entry for each IPv6 multicast source, consuming
a lot of system resources.
IPv6 BIDIR-PIM addresses the problem. Derived from IPv6 PIM-SM, IPv6 BIDIR-PIM builds and maintains
a bidirectional RPT, which is rooted at the RP and connects the IPv6 multicast sources and the receivers.
Along the bidirectional RPT, the IPv6 multicast sources send IPv6 multicast data to the RP, and the RP
forwards the data to the receivers. Each router along the bidirectional RPT needs to maintain only one (*,
G) entry, saving system resources.
IPv6 BIDIR-PIM is suitable for a network with dense IPv6 multicast sources and receivers.
Neighbor discovery
IPv6 BIDIR-PIM uses the same neighbor discovery mechanism as IPv6 PIM-SM does. For more information,
see "Neighbor
RP discovery
IPv6 BIDIR-PIM uses the same RP discovery mechanism as IPv6 PIM-SM does. For more information, see
"RP discovery." In IPv6 BIDIR-PIM, an RPF interface is the interface toward an RP, and an RPF neighbor
is the address of the next hop to the RP.
discovery."
282
"IPv6 multicast source