Configuration Examples; Ipv6 Multicast Forwarding Over A Gre Tunnel - HP 6125XLG Ip Multicast Configuration Manual

Blade switch
Table of Contents

Advertisement

Configuration examples

IPv6 multicast forwarding over a GRE tunnel

Network requirements
As shown in
Switch B does not support IPv6 multicast. OSPFv3 is running on Switch A, Switch B, and Switch C.
Configure the switches so that the receiver host can receive the IPv6 multicast data from the source.
Figure 81 Network diagram
IPv6 multicast router
Switch A
XGE1/1/7
Vlan-int100
1001::1/64
Configuration procedure
1.
Configure the IPv6 address and prefix length for each interface as shown in
shown.)
2.
Enable OSPFv3 on the switches to meet the following requirements: (Details not shown.)
The switches are interoperable at the network layer.
The switches can dynamically update their routing information.
3.
Configure a GRE tunnel:
# On Switch A, create service loopback group 1, and specify its service type as Tunnel.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Add Ten-GigabitEthernet 1/1/7 to service loopback group 1. Ten-GigabitEthernet 1/1/7 does
not belong to VLAN 100 or VLAN 101.
[SwitchA] interface ten-gigabitethernet 1/1/7
[SwitchA-Ten-GigabitEthernet1/1/7] port service-loopback group 1
[SwitchA-Ten-GigabitEthernet1/1/7] quit
# Create interface Tunnel 0, and specify the tunnel encapsulation mode as GRE over IPv6.
[SwitchA] interface tunnel 0 mode gre ipv6
# Assign an IPv6 address to interface Tunnel 0, and specify its source and destination addresses.
[SwitchA-Tunnel0] ipv6 address 5001::1 64
[SwitchA-Tunnel0] source 2001::1
[SwitchA-Tunnel0] destination 3001::2
[SwitchA-Tunnel0] quit
Figure
81, IPv6 multicast routing and IPv6 PIM-DM are enabled on Switch A and Switch C.
Vlan-int101
Vlan-int101
2001::1/64
2001::2/64
Tunnel0
5001::1/64
Source
1001::100/64
IPv6 unicast router
Switch B
Vlan-int102
3001::1/64
GRE tunnel
Member port of the
service loopback group
260
IPv6 multicast router
Switch C
Vlan-int102
3001::2/64
XGE1/1/7
Vlan-int200
4001::1/64
Tunnel0
5001::2/64
Receiver
4001::100/64
Figure
81. (Details not

Advertisement

Table of Contents
loading

Table of Contents