Configuring Switchover To Spt; Configuring Ipv6 Bidir-Pim; Ipv6 Bidir-Pim Configuration Task List - HP 6125XLG Ip Multicast Configuration Manual

The ACL does not define a deny or permit action for a matching register message.
•
In view of information integrity of a register message in the transmission process, you can configure the
device to calculate the checksum based on the entire register message. If a device that does not support
this function is present on the network, you can configure the device to calculate the checksum based on
the register message header.
To configure IPv6 multicast source registration:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure a filtering rule for
register messages.
4. Configure the device to
calculate the checksum based
on the entire register
message.

Configuring switchover to SPT

CAUTION:
If the router is an RP, disabling switchover to SPT might cause multicast traffic forwarding failures on the
source-side DR. When disabling switchover to SPT, be sure you fully understand its impact on your
network.
To configure switchover to SPT:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure the criteria for
triggering a switchover to SPT.

Configuring IPv6 BIDIR-PIM

This section describes how to configure IPv6 BIDIR-PIM.

IPv6 BIDIR-PIM configuration task list

Task at a glance
(Required.) Enabling IPv6 BIDIR-PIM
Command
system-view
ipv6 pim [ vpn-instance
vpn-instance-name ]
register-policy acl6-number
register-whole-checksum
Command
system-view
ipv6 pim [ vpn-instance
vpn-instance-name ]
spt-switch-threshold { immediacy |
infinity } [ group-policy
acl6-number ]
297
Remarks
N/A
N/A
By default, no register filtering rule
exists.
By default, the device calculates
the checksum based on the header
of a register message.
Remarks
N/A
N/A
By default, the device immediately
triggers a switchover to SPT after
receiving the first multicast packet.