Pim-Sm Non-Scoped Zone Configuration Example - HP 6125XLG Ip Multicast Configuration Manual

Upstream interface: Vlan-interface103
Upstream neighbor: 192.168.1.2
RPF prime neighbor: 192.168.1.2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface100
# Display the PIM routing table information on Switch D.
[SwitchD] display pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(10.110.5.100, 225.1.1.1)
Protocol: pim-dm, Flag: LOC ACT
UpTime: 00:03:27
Upstream interface: Vlan-interface300
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 2
1: Vlan-interface103
2: Vlan-interface102
The output shows the following:
Switches on the SPT path (Switch A and Switch D) have the correct (S, G) entries.
•
Switch A has the correct (*, G) entry.
•

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub
•
networks, and at least one receiver host exist in each stub network. The entire PIM-SM domain
contains only one BSR.
• Host A and Host C are multicast receivers in two stub networks N1 and N2.
Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to the
•
multicast group range 225.1.1.0/24. Specify VLAN-interface 101 of Switch D as the static RP on all
the switches to back up the dynamic RP.
• IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Protocol: pim-dm, UpTime: 00:04:25, Expires: -
Protocol: pim-dm, UpTime: 00:03:27, Expires: -
Protocol: pim-dm, UpTime: 00:03:27, Expires: -
Figure 46:
120