HP 6125XLG Ip Multicast Configuration Manual page 257

Figure 77 Network diagram
Configuration procedure
1. Configure Switch A:
# Enable IPv6 multicast routing.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
# Create VLAN 20, and assign Ten-GigabitEthernet 1/1/6 to this VLAN.
[SwitchA] vlan 20
[SwitchA-vlan20] port ten-gigabitethernet 1/1/6
[SwitchA-vlan20] quit
# Assign an IPv6 address to VLAN-interface 20, and enable IPv6 PIM-DM.
[SwitchA] interface vlan-interface 20
[SwitchA-Vlan-interface20] ipv6 address 1::2 64
[SwitchA-Vlan-interface20] ipv6 pim dm
[SwitchA-Vlan-interface20] quit
# Create VLAN 10.
[SwitchA] vlan 10
[SwitchA-vlan10] quit
# Configure Ten-GigabitEthernet 1/1/5 as a hybrid port, and assign it to VLAN 10 as a tagged
VLAN member.
[SwitchA] interface ten-gigabitethernet 1/1/5
[SwitchA-Ten-GigabitEthernet1/1/5] port link-type hybrid
[SwitchA-Ten-GigabitEthernet1/1/5] port hybrid vlan 10 tagged
[SwitchA-Ten-GigabitEthernet1/1/5] quit
# Assign an IPv6 address to VLAN-interface 10, and enable MLD.
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ipv6 address 2001::1 64
[SwitchA-Vlan-interface10] mld enable
247