HP 6125XLG Ip Multicast Configuration Manual page 289

The BSR encapsulates the RP-set information in the bootstrap messages (BSMs) and floods the BSMs to
the entire IPv6 PIM-SM domain.
Figure 88 Information exchange between C-RPs and BSR
Based on the information in the RP-set, all routers in the network can select an RP for a specific IPv6
multicast group based on the following rules:
1. The C-RP that is designated to a smallest IPv6 multicast group range wins.
2. If the C-RPs are designated to the same group range, the C-RP with the highest priority wins.
3. If the C-RPs have the same priority, the C-RP with the largest hash value wins. The hash value is
calculated through the hash algorithm.
4. If the C-RPs have the same hash value, the C-RP with the highest IPv6 address wins.
Embedded RP
The embedded RP mechanism enables a router to resolve the RP address from an IPv6 multicast group
address to map the IPv6 multicast group to an RP. This RP can take the place of the configured static RP
or the RP dynamically elected by the bootstrap mechanism. A DR does not need to learn the RP address
beforehand. The process is as follows:
At the receiver side:
•
a. A receiver host initiates an MLD report to express its interest in an IPv6 multicast group.
b. After receiving the MLD report, the receiver-side DR resolves the RP address embedded in the
IPv6 multicast group address and sends a join message to the RP.
• At the IPv6 multicast source side:
c. The IPv6 multicast source sends IPv6 multicast traffic to an IPv6 multicast group.
d. The source-side DR resolves the RP address embedded in the IPv6 multicast address, and sends
a register message to the RP.
279