Configuring Ipv6 Multicast Routing And Forwarding; Configuring The Rpf Route Selection Rule; Configuring Ipv6 Multicast Load Splitting - HP 6125XLG Ip Multicast Configuration Manual

To enable IPv6 multicast routing:
Step
1. Enter system view.
2. Enable IPv6 multicast routing
and enter IPv6 MRIB view.

Configuring IPv6 multicast routing and forwarding

Before you configure IPv6 multicast routing and forwarding, complete the following tasks:
Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
•
network layer.
• Configure IPv6 PIM-DM or IPv6 PIM-SM.

Configuring the RPF route selection rule

You can configure the router to select the RPF route based on the longest prefix match principle. For more
information about RPF route selection, see
To configure an IPv6 multicast routing policy:
Step
1. Enter system view.
2. Enter IPv6 MRIB view.
3. Configure the device to select
the RPF route based on the
longest prefix match.

Configuring IPv6 multicast load splitting

By configuring per-source or per-source-and-group load splitting, you can optimize the traffic delivery
when multiple IPv6 multicast data streams are handled.
You do not need to enable IPv6 multicast routing before this configuration.
To configure IPv6 multicast load splitting:
Step
1. Enter system view.
2. Enter IPv6 MRIB view.
3. Configure IPv6 multicast load
splitting.
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
"RPF check process."
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
longest-match
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
load-splitting {source |
source-group }
256
Remarks
N/A
By default, IPv6 multicast routing is
disabled.
Remarks
N/A
N/A
By default, the route with the
highest priority is selected as the
RPF route.
Remarks
N/A
N/A
By default, IPv6 multicast load
splitting is disabled.