Printing Measured Values (Mode / Print Button); Instantaneous Printing Of Measurements (Print Result) - AEMC 5070 User Manual

6.4 Printing Measured Values
To use a serial printer, first choose the appropriate communication baud rate in the
SET-UP menu, between 300...9600 baud. Then program the printer to the 5070
format.
There are two print modes:
• Instantaneous printing of measurement (PRINT)
• Printing of recorded data (PRINT memory)
Pressing the PRINT button gives access to the following menu:
• Print result: Immediate printing of a measurement following that mea-
surement or after accessing values in the MR mode.
• Print memory: Printing of stored data.
• Baud rate / Port: Baud rate adjusted in the SET-UP menu. The choices
are 300, 600, 1200, 2400, 4800, 9600 or parallel.
After selection of the print mode :
• If the transmission of data to the printer is successful, the COM
symbol flashes at the top left of the display unit.
• If a problem occurs, the COM symbol remains lit steadily at the top left
of the display unit.
6.5 Instantaneous Printing of Measurements
When this print mode is selected, the following are printed, in order:
• General information concerning the measurement
• The measurement result
• If the TEMP function was activated, the measurement result referred to
the reference temperature
• For a Timed Run test, the list of recorded samples
To stop printing, move the position of the selector switch to any other position.
64
(MODE / PRINT Button)
(Print Result)
Megohmmeter Model 5070