Table of Contents
Advertisement
Use only factory specified replacement parts. AEMC
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.
8.1 Recharging the Battery
If the
symbol is flashing, the battery needs to be recharged.
Connect the instrument to the 120V
starts automatically even if the instrument is turned off).
• If the instrument is charging in the OFF position: the battery symbol
is displayed and the 3 bars flash throughout the charging - "Charging bat-
tery" is also indicated. When the battery is full, the symbol and its 3 bars
are lit steadily and "Charging Full" is indicated.
• If the instrument is charging in a measurement position: the battery
symbol flashes. There is no full charge indication. The "Charging Full"
indication is displayed only when the instrument is returned to the OFF
position.
If the instrument is turned on and the battery voltage is >8V, then the normal use
of the device is permitted.
The battery should be replaced by an authorized repair facility recognized
by AEMC
®
WARNING: Changing the battery causes data to be lost from the
memory.
Press the MEM /MR button ("OFF" is displayed). Proceed with a total clearing of
memory in SET-UP (see §4.8) so the MEM /MR functions can be used again.
Megohmmeter Model 5070
CHAPTER 8
MAINTENANCE
Instruments.
will not be held responsible
®
power cord via the connector (charging
AC
85
Advertisement
Table of Contents
