Lcd80 Operation - Notifier AFP-2800 Operation, Installation & Programming Manual

8.4 LCD80 O
8 . 4 . 1 L C D 8
8 . 4 . 1 L C D
The LCD80 is an alphanumeric display module that acts as a remote display interface to the AFP-2800/2802. It
displays Alarm, Fault and Isolate lists. A local buzzer will sound for any alarm or fault (this buzzer can be disabled
if required). The AFP-2800/2802 can support up to 32 LCD80 units on Ring 1. Refer to page 137 for connection,
addressing and set-up details.
8.4.1.1 N
ORMAL
The display will automatically show the highest priority event in the FIP event queue. Priorities, in descending
order, are Alarms, Faults, and then Isolates. In the event that a fault is showing on the display and an alarm
occurs, the display will automatically change to show the alarm. Totals of all Alarms, Faults and Isolates are also
shown and are automatically updated every 10 seconds.
8.4.1.2 M
ANUAL

Pressing "DISPLAY ALARMS" will show the first alarm in the alarm list

Pressing "DISPLAY FAULTS" will show the first fault in the fault list

Pressing "DISPLAY ISOLATES" will show the first isolate in the isolate list

Pressing the "NEXT" and "PREVIOUS" buttons allow the user to scroll up and down the lists. When the last
event on the list is reached, the display will wrap around to the first event on the list, and vice versa.

The mute key can also be used like a shift key to provide the following service functions
Shift "NEXT" Contrast up
Shift "PREV" Contrast down
Shift "DISPLAY ALARMS" show Software Version
Note: If a new event occurs on the FIP, then the highest priority event will automatically be displayed.
AFP-2800/2802 Manual – P/N 11249 11-Mar-08
PERATION
0 – T M
8 0 – T M
E R M I N A L
E R M I N A L
O
PERATION
O
PERATION
O D E
O D E
10 SEPT 12:34 1/1
EAST WING
1.2.Z6 FAULT
*A=0 F=1 I=0
Display
Next
Alarms
Display
Previous
Faults
Display
Mute
Isolates
Appendix
95