Notifier AFP-2800 Operation, Installation & Programming Manual page 121

8.7.5.2 N .F
OTI
Channel A & B
connections
Ground Fault
detection switches
and Network End Of
Line Termination
Resistor switches
From last node,
Port A
Note:
Wiring from the NCM-W that is installed outside buildings:
- Must be in conduit and be buried in a trench separate from any power lines
- Cannot cross any power lines
NCM-W Connections:
Connector Pin
TB100-1
TB100-2
TB100-3
TB100-4
TB100-5
AFP-2800/2802 Manual – P/N 11249 11-Mar-08
.N ™ NCM S
IRE ET
B A
Signal Name
CH-A (+)
CH-A (-)
CH-B (+)
CH-B (-)
Earth Ground
& T
WITCHES ERMINATIONS
Network connection
ports (NUP)
Diagnostic LEDs
B
Channel-A Driver / Receiver
Channel-A Driver / Receiver
Channel-B Driver / Receiver
Channel-B Driver / Receiver
Not used
To next node,
Port B
A
CONNECTION
DETAIL
Appendix
119