Notifier AFP-2800 Operation, Installation & Programming Manual page 70

Panel Operation
6.3.6.9 S
ERVICE
In this screen an AZF may be tested to verify its ability to detect an Alarm or Fault condition.
AZF TEST MENU
DAY MODE
20 JULY 2002 14:44:37
TESTING AZF POINT 1.2.Z3
POINT STATUS:
TEST MODE IS AUTOCLEAR
SENDING ALARM TEST...GOOD RX
WAITING FOR POINT 1.2.Z3 TO ALARM
OK...CLEARING POINT
WAITING FOR POINT 1.2.Z3 TO CLEAR
OK....CLEARING ALARM/FAULT LIST
USE BUTTONS TO SELECT A TEST
ISOL ALARM

All tests will require the operator to manually reset the alarm or fault after the test.

If the alarm test or fault test fails a message of
TIMEOUT ON ALARM/FAULT!!
or
TIMEOUT ON CLEAR!!
If this occurs the module should be immediately investigated for faults.
Note: The AZF tests generate a real alarm or fault condition at the remote module, so the module itself is tested as
well as the panel to module communications.
6.3.6.10 S
ERVICE
Will prompt the operator to enter the device address to be fault or alarm tested.
Note: The Analog tests do not generate a real alarm or fault condition at the device. A successful test is not an
indication of the device's ability to report a real alarm condition, its only an indication of proper
communication between the LCM and FIP.
68
M – T
ENU EST
A = 0
F = 0
I = 0
N = 1
FAULT BACK
M – T
ENU EST
– A /F
LARM AULT
Actions:

An ISOL button is provided so that the point can
be easily isolated during the test period, this
button will toggle to DEISOL if the point is
already isolated.

A single button press of the ALARM or FAULT
buttons is all that is required to initiate the tests.

Pressing the BACK button will return to the
previous screen.

Note that an isolated point is seen as inactive by
the panel and hence, in a logic programming
script, it will return the value FALSE (or TRUE if
the NOT function is applied to it within the script).
– A /F
LARM AULT
AFP-2800/2802 Manual – P/N 11249 11-Mar-08
– AZF
– A
NALOG