Notifier AFP-2800 Operation, Installation & Programming Manual page 71

6.3.6.11 S
ERVICE
In this screen a digital output may be tested to verify its ability to operate when required.
DIGITAL OUTPUT TEST MENU
DAY MODE
20 JULY 2002 14:44:37
TESTING DIGITAL OUTPUT POINT
POINT STATUS:
SCRIPT PROCESSING PAUSED
TEST BUTTON WILL TOGGLE STATE
TEST

All script processing is paused while in test mode to provide positive control of the output state. Scripts
automatically recommence processing when test mode is exited.

Test mode will automatically exit after 10 minutes from the last button press to prevent the system remaining
off line.

If a digital output does not have a control script and is set on during test mode, the output will remain on
permanently until turned off through test mode. This can be a useful function for testing purposes during
commissioning.
Note: As the Dout tests activate the output at the remote module, the module itself is tested as well as the panel to
module communications.
6.3.6.12 S
ERVICE
This function will run a load test on the batteries for 15 seconds, and if a battery fault is detected, it will be
displayed and logged as such to the history. A successful Battery Test will clear a battery fault. The panel also
performs a short battery integrity test every hour.
Note: The battery test will not run if there is a Mains Fail condition, so as not to further deplete the battery charge.
AFP-2800/2802 Manual – P/N 11249 11-Mar-08
M – T
ENU EST
A = 0
F = 0
I = 0
N = 1
1.2.O3
OFF
BACK
M – T
ENU EST
– D
OUT
Actions:

A single press of the TEST button will toggle the
output between on and off.

Pressing the BACK button will return to the
previous screen.
– B
ATTERY
Panel Operation
69