GPI -122 Instruction Manual page 58

Baud: 115200
Filename: A.COO
No.: 21
Fast Slow File Import
Baud: 115200
Filename: A.MEA
No.: 33
Fast Slow File Export
--Program--
Warning!
1.REM(Height meas)
2.MLM
Format will lose data
3.Coor.Z
ENT 彐 Continue
4.Area
5.Point projecting
ESC 彐 Quit
6.Roadway
--Program--
1.REM(Height meas)
2.MLM
Availability space
3.Coor.Z
2004KB
4.Area
5.Point projecting
6.Roadway
Pt.name SUN9
Code: MY
N: 111
E: 222
Z: 21
B.S. Clear Num.
the end record.F2:【PgUp】to show the previous
record.F3:【PgDn】to show the next record.【
to edit the record if '*'is on the interface. only
point name ,code and height can be edited.
5. A coordinates file and code file can be imported
from the peripheral PC through RS232 serial
interface. the Baud ratio is set by pressing F1:
【Fast】or F2:【Slow】,the baud ration set is
2400,4800,9600,19200,38400,57600 and
115200,another config is no parity ,1 start bit and 1
stop bit.after you select filename you can press F4:
【Import】to perform the convection.
6. Measurement file can be exported from the
RS232,the operation is same as the【Importing】
7. Sometimes, many files have been saved in the
instrument, it will take a long time to delete these
▲
files one by one.formating the disk would be a
good idea, when you format the disk, the prompt as
the picture on the left will appear. so you must save
▼
all measurement data before you format.
▲
8. Sometimes, you wish to view the fress space of
the disk, you can select the menu item 5 to do it.
▼
9. Sometime, you need to previously input some
coodinates for the subsequent using. then you can
use the menu item 6 to input data.
m
Enter
57
★
】