How To Configure - GPI -122 Instruction Manual

Setup station
Pt.name SUN .
STN
STE
STZ
B.S. Clear Num.
6. Press【1】,'SUN1' will present in input box
7. Press【F3】,switch into Alphabet input mode
8. Press【1】,'SUN1A' will present in input box
9. Press【F4】,the cerat will shift into STN input box, because the STN coordinate is
Number attribute, the prompt "Alph." automatically switch into "Num.",
10. Input【±】,【1】,【2】,【3】,【.】,【4】,【5】,【6】in turn,
11. Press【ENT】，end dialog

3.7 How to Configure

Press key {★} directly to enter into in any status, and do some basic settings.
Reflector: Prism 彡
Contrast: 5
[*] Choose file
Light Tilt Point-to Factor
Reflector: Prism 彡
Contrast: 5
Tilt:-50
[*] Choose file
Light Tilt Point-to Factor
Temperature:
Press: 1013.0 hPa
Prism const:
PPM:
Signal:
B.S. Clear Sigal Enter
next alphabet 'U' is relational with【7】.click
【7】,'SS' will present in inputbox, click【7】
again 'ST' will present in inputbox, click【7】
again, 'SU' will present in input box.
4. Click【5】, 'SUN' will present in input box.
Enter
5. Press【F3】,switch into Number input mode
1. Backlight
Press 【 F1】 , the backlight will be switched on or off
◆
2. Tilt
Press【F2】,the tilt sensor status will be present
Press 【F2】 again the tilt sensor will be switch on or
off
【ESC】will quit tilt sensor status display
◆
3. Point-to
Press【F3】,the laser beam will appear, press【F3】
again the laser beam will disappear.
4. Reflecting object
25 ℃
Press the EDM mode will be switched between
0 mm
"prism"," no prism" and "reflector board"
4ppm
5. LCD contrast
▼▲
Press
contrast
18
,will increase or decrease the value of