Coordinate Measurement; Input The Occupied Point Data - GPI -122 Instruction Manual

6. Coordinate Measurement

It is possible to find the 3D coordinates of a target by coordinate measurement. Please
input the Station coordinate, instrument height, target height, backsight. Coordinate（or
azimuth angle）and azimuth before coordinate measurement.
Z

6.1 Input the Occupied Point Data

【Procedure of inputting occupied point data】
Vz: 92°18' 22"
HR: 0°00' 18"
N: cont
E:
Z:
Save Meas Mode
Vz: 92°18' 22"
HR: 0°00' 18"
N: cont
E:
Z:
Setup BSS STA
Set station
>STA:
Code
I.H.: 1.800
* file list
Input Pop Info
N
Inst. Ht
Occiped point
1. Measure the height of target and instrument with
a tape, etc.
m
2. Press F4: 【 P1/3】at P1 in the measurement mode
P1/3
to next page
3. Press F3:【STA】to setup station.
m
4. Press F1:【Input】the station coordinate, note to
P2/3
input a pointname. if the station is a known point
whose information have been saved in current
coordinate file, then you can press
F2:【Pop】to call a point（coordinate）information
for the station. if you cannot remember the point
Read
name in current coordinate file then you can press
22
Target Ht
Target point
E