GPI -122 Instruction Manual page 26

Where：
N0-E0-Z0: occupied point coordinates
S：SD
IH：Instrument height
N
【Procedure of 3D coordinates measurement】
Vz: 92°18' 22"
HR: 0°00' 18"
N: cont
E:
Z:
Save Meas Mode
Input I.H. &T.H.
I.H.:
T.H.:
B.S. Clear Save Enter
Z：Zenith angle
SD
Z
Zenith angle
IH
N0-E0-Z
Azimuth angle
1. Aim at the target point.
2. Select F2:【Meas】to start. The coordinate value
m
of the target is displayed.
3. Press F2:【STA】to re-input the occupied data if
P1/3
necessary, see "§6.1 Input the occupied point data".
4. Press F1: 【Setup】 to re-input the target height and
instrument height if necessary, and press F1:
【MEAS】to continue. Follow this operation till all
m
targets have been measured.
5. Press key【ESC】to stop EDM measuring, when
EDM mode is" Continue", "Repeat" or "Track"
25
Az：Azimuth angle
TH：Target height
Target height
Target (N-E-Z)
HD
0
E