KEB COMBIVERT F5 Instruction Manual page 30

Operator Parameters
Standard value:
Note:
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
30
bit3 = 1 PDAPI_Disable: For the function to be able to exchange acyclic data
with a standard Siemens S7 PROFINET controller to PROFIDRIVE
Base Mode Parameter Access, the F5 PROFINET operator has a
second API with value = 3A00h. The module with the name ,ProfiD-
rive_PAP' is assigned to this API. Via this bit the complete functional-
ity of the API = 3A00h can be disabled with the module ,ProfiDrive_
PAP'. In this case the acyclic communication to PROFIDRIVE Base
Mode-Parameter-Access can be executed also via the standard API
with value = 0.
bit4 = 1 The default PD mapping is written when starting the software to the
frequency inverter, if bit5 = 1.
bit4 = 0 The non-volatile stored PD mapping in the operator (see Fb28 to
Fb31) is written to the frequency inverter at boot-up, if bit5 = 1.
bit5 = 0 Writing the PD mapping to the frequency inverter control is deacti-
vated at boot-up.
bit5 = 1 Writing the PD mapping to the frequency inverter control is activated
at boot-up.
bit6 = 1 When addressing the parameters to PROFINET acyclic data the
subindex is not bit-coded, but linearly coded.
bit7 = 1 Activation of the PROFINET alarm signals. When the alarm is acti-
vated, the operator monitors the value of the inverter parameter ru00
„inverter state" (see chapter 3.11).
0
A new value is stored non-volatile, but only active at the next switch on.
Fb02
DelayTimeSyncToAppllrq
Is only relevant for the synchronous communication mode (PROFINET IO/IRT).
This parameter defines the delay time between PROFINET-Sync-Signal and
communication interrupt.
0282h
0
Uint16
1 µs
500 µs
A changed value is stored immediately active and non-volatile.