ELECTRO FREEZE CS700-FG Operator's Manual page 44

ELECTRO FREEZE Shake Model CS700-FG
13 Troubleshooting Charts
PROBLEM PROBABLY CAUSE
Compressor
and beater
motor operate 1. Defective torque control or recycle timer.
only when
dispensing.
1. Low line voltage.
Compressor
does not
start – hums
2. Improperly wired.
intermittently
(cycling on
overload).
3. Open starting capacitor or current relay.
4. High discharge pressure.
NOTE: Contact your authorized Electro Freeze distributor for
Keep your freezer in excellent condition. Always contact
your Electro Freeze distributor for replacement parts and
maintenance scheduling.
34
instructions prior to warranty compressor replacement.
— continued
REMEDY
Contact your Electro Freeze
1.
Distributor for service.
Ask power company to check volt-
age, increase voltage to not less than
1. 10% below data plate rating or install
transformer. Have electrician check
for inadequate wire size.
Contact your Electro Freeze
2.
distributor for service.
Contact your Electro Freeze
3.
distributor for service.
Contact your Electro Freeze
4.
distributor for service.
QUALITY PARTS
PROTECT
YOUR
EQUIPMENT
185231-17