ELECTRO FREEZE CS700-FG Operator's Manual page 38

ELECTRO FREEZE Shake Model CS700-FG
12 Routine Maintenance
A. Test Head Switch.
The head switch feature is designed
to prevent the beater shaft from being
accidentally activated. It is essential
that the proper operation of this switch
be verified on a routine basis. Use the
following instructions to test for proper
operation:
1. Be sure all switches are in the
"OFF" position.
2. Disconnect the main power
supply.
3. Remove the dispense head and
beater shaft assembly.
4. Connect the main power supply.
5. Turn the selector switch to the
"CLEAN" position.
6.
toward the rear. The drive shaft coupling
should NOT be turning. Turn the switch
off and disconnect the main power supply.
7.
turning, or you are unable to determine
whether or not the shaft is turning,
turn the switch to the "OFF" position,
disconnect the main power supply, and
contact your Electro Freeze distributor
for service. DO NOT place the freezer in
service until the problem has been fixed.
28
MONTHLY
CAUTION
Moving parts. Do not place
hands in the freezing cylinder.
Severe personal injury could
result.
Look inside the freezing cylinder
If the drive shaft coupling is
— continued
MONTHLY
B. Air Filter.
Clean the air filter with a mild dish
detergent solution.
185231-17