Troubleshooting Table - ELECTRO FREEZE CS700-FG Operator's Manual

13 Troubleshooting Charts
PROBLEM PROBABLY CAUSE
Product
1. Product too cold.
dispenses
slowly out of
dispensing
2. Wrong rotation on beater.
head.
1. Torque control erratic or set too firm
Dispensed
product too
hard.
2.
1. Plunger switch rod engaged.
2. Starter or relay contact points stuck.
Freezer runs
continually and
product gets
3. Torque control not set properly or faulty.
too cold.
4. Suction pressure too low.
Compressor
1.
and beater
motor do not
operate when
2. Time delay defective.
dispensing.
1.
Compressor
motor does not
2. Time delay defective.
operate when
dispensing.
3. Defective torque control.
185231-17
ELECTRO FREEZE Shake Model CS700-FG
Low suction pressure, refrigeration
system.
Plunger switch(es) defective or out of
adjustment.
Plunger switch defective or out of adjust-
ment.
— continued
REMEDY
See Troubleshooting Table -
1.
Dispensed product too hard.
Have an electrician correct rotation to
2. clockwise as viewed from the front of
the freezer.
Contact your Electro Freeze
1.
distributor for service.
Contact your Electro Freeze
2.
distributor for service.
1. Close plunger completely.
Contact your Electro Freeze
2.
distributor for service.
Contact your Electro Freeze
3.
distributor for service.
Contact your Electro Freeze
4.
distributor for service.
Contact your Electro Freeze
1.
Distributor for service.
Contact your Electro Freeze
2.
Distributor for service.
Contact your Electro Freeze
1.
distributor for service.
Contact your Electro Freeze
2.
distributor for service.
Contact your Electro Freeze
3.
distributor for service.
33