ELECTRO FREEZE CS700-FG Operator's Manual page 17

4 Part Names and Functions
The following part names and descriptions refer to figure 4-1.
1.) HEAD - ASSY. DISPENSE: Encloses
2.) BUSHING - BEATER BEARING:
3.) O-RING - HEAD: Seals the head
4.) O-RING - PLUNGER LOWER: Seals
5.) O-RING - PLUNGER UPPER: Seals
6.) PLUNGER: Seals the product opening
7.) ROD - ACTUATOR: Starts the freezer
8.) SPINDLE - ASSY.: Mixes the shake
9.) O-RING - SPINDLE: Holds the spindle
10.) HANDLE - DISPENSE: Opens and
11.) STUD - ASSY.: Hand knobs screw on
12.) KEEPER: Secures the handle to the
13.) BAR-SLASH SHIELD: Attaches the
14.) KNOB - HAND: Secures the head to
185231-17
ELECTRO FREEZE Shake Model CS700-FG
the freezing cylinder and provides an
opening for product to be dispensed.
Holds the beater in place at the front of
the cylinder. Must be inserted into the
head and lubricated before assembly.
to the freezing cylinder. Must be
lubricated.
the plunger in the head. Must be
lubricated to seal and slide properly.
the plunger in the head. Must be
lubricated to seal and slide properly.
in the head when closed. Allows product
to flow when open.
when dispensing. Must be in place
before freezer will operate.
as it is dispensed.
or pivot post in place.
closes the plunger to start and stop the
flow of product from the freezer.
studs to hold head assembly in place.
head.
splash shield to the dispense head.
the freezing cylinder.
— continued
7