ELECTRO FREEZE CS700-FG Operator's Manual page 26

ELECTRO FREEZE Shake Model CS700-FG
6.3 Cleaning Instructions
Figure 6-6 Clean shaft seal and plunger
Figure 6-7 Clean scraper blades
Figure 6-8 Clean hopper and mix feed port
16
— continued
c. The shaft seal and plunger
O-ring grooves (figure 6-6).
d. The beater shaft and the
scraper blade pin holes, shown in
figure 6-7.
3. After all parts are washed and
rinsed place them in the sanitizing
solution. For proper sanitizing, all parts
must remain fully immersed in the
sanitizer for 5 minutes. Allow parts to
air-dry after sanitizing.
Do not leave parts in sanitizer for more
than 15 minutes.
4. Wash hopper walls and all soiled
surfaces on the freezer with a clean
disposable towel. Using proper brush,
brush the hopper, the hopper inlet tube
(figure 6-8), the cylinder and cylinder back
wall (figure 6-9) thoroughly. Rinse using
rinse bottle. Using sanitizing solution,
repeat brushing and rinsing procedure
making sure all surfaces contact sanitizer.
5. Brush the inside of the drain tube
with sanitizing solution, as shown in figure
6-9.
Drain Tube
Figure 6-9 Clean drain tube and cylinder
Replace worn brushes. Use
only Electro Freeze original
or authorized replacement
parts. See Accessories
Parts List in Part II of
this manual to order new
Important:
Cylinder
brushes.
185231-17