Yamaha CL5 Reference Manual page 82

CH LINK MODE window (output channels)
You can view the output channels that are linked and specify the parameters that will be
linked.
5
1
2
3
4
1
Output channel display field
When you create a link group, the corresponding output channels will be highlighted.
If there are two or more link groups, each group is shown in a different color. Press this
field to open the CH LINK SET window. You can also link output channels in this window.
NOTE
In the case of the CL3 and CL1, faders that do not exist on those models will not be shown.
2 Link indicator
If an output channel belonging to a link group is selected, the associated link group is
shown. The LINK PARAMETER field and SEND PARAMETER field show the link
While you hold down the [SEL] key of an output channel that does not belong to any
link group, the link indicator shows the link group that will be created next. The LINK
PARAMETER field and SEND PARAMETER field show the settings of the link group that
had been previously displayed.
3 LINK PARAMETER field
Use the buttons in this field to select the parameters that you want to be linked. You can
do this independently for each link group.
The table below lists the parameters you can select in the LINK PARAMETER field.
EQ
DYNAMICS
INSERT
MATRIX SEND
MATRIX ON
FADER
CH ON
TO STEREO
DCA
MUTE
*1 MATRIX channel not applicable
NOTE
• If you link Dynamics for two or more output channels, the parameter values will be linked, but the
key-in sources are not linked and can instead be set for each channel. The behavior of key-in
signals is linked in units of 8ch*. For details about dynamics, see
* Units of 8ch refers to MIX 1 - MIX 8/MIX 9 - MIX 16/MIX 17 - MIX 24/MATRIX 1 - MATRIX 8.
• If you turn on the EQ button or DYNAMICS button, library recall operations will also be linked.
• In the insert settings, the parameters for Insert 1 and Insert 2 are selected together.
4
SEND PARAMETER field
If you have turned on the MATRIX ON or MATRIX send buttons in the LINK PARAMETER
field, use the buttons in this field to specify the send-destination bus(es).
MTRX 1-8
NOTE
If nothing is selected in the SEND PARAMETER field, send on/off and send level will not be
linked.
5
INPUT/OUTPUT button
Use this button to switch between the Input Channels screen and the Output Channels
screen.
settings.
79
EQ settings
Dynamics settings
Insert settings
Send levels of signals sent to MATRIX buses *1
On/off status of signals sent to MATRIX buses *1
Fader operations
Channel on/off
On/off status of signals sent to STEREO/MONO buses *1
DCA group assignment
Mute group assignment
MATRIX buses 1-8
Channel Job
"EQ and
Dynamics" (page 58).
Reference Manual