◆ Remotely controlling from the input channels
To remotely control the I/O device's head amp from an input channel of the CL series console,
operate the GAIN/PATCH window for the channel for which you want to control.
Remotely controlling an amp
This section explains how to remotely control an AMP unit that's connected to the Dante
connector.
STEP
1. Press the AMP tab in the upper part of the I/O DEVICE screen.
2. Press the I/O device displayed on the I/O DEVICE screen (AMP page).
3. Set the output port on the OUTPUT PATCH window, as necessary.
Refer to step 7 in
"I/O device
patching"
(page
154).
I/O DEVICE screen (AMP page)
1
2
Press one of these buttons to view the corresponding I/O device.
For more information about VIRTUAL/CONFLICT/DUPLICATE displayed below this
button, refer to (1) on P.154,
This shows the ID number, model name, and version of the I/O device.
Press this button to open the DANTE SETUP window, in which you can make settings
for the audio network.
159
I/O devices and external head amps
3
1
Display switch buttons
"I/O device
list".
2
ID/Model name display
3
DANTE SETUP button
Reference Manual