Yamaha CL5 Reference Manual page 161

5 MADI STATUS INPUT status
MADI STATUS OUTPUT status
Display information regarding the MADI input and output signals (frame frequency/
number of channels).
6
WORD CLOCK WCLK IN indicator
WORD CLOCK MADI indicator
WORD CLOCK DANTE indicator
WORD CLOCK WCLK IN/MADI/DANTE buttons
Used to select the word clock source.
Uses the word clock signal being input from the WORD CLOCK IN connector on
WCLK IN the rear panel of RMio64-D. The indicators flash when there is no valid word clock
input.
Uses the word clock of the MADI input signal. The indicators flash when there is no
MADI
valid word clock input.
DANTE Uses the word clock of the Dante network.
7 WORD CLOCK Fs indicator
Indicates the word clock frequency at which the unit is operating. Flashes when not
synchronized.
8
EXTERNAL CONTROL indicator
This indicator comes on when there is a valid parameter that can be operated only
externally by remote control.
Refer to "Remote Control" in the RMio64-D Owner's Manual for details about
parameters that can be operated by remote control.
9 OUTPUT PATCH button
Press this button to access the OUTPUT PATCH window, where you can make output
port settings for RMio64-D.
I/O DEVICE HA window
Displayed when you press the rack in which the I/O device on the head amp side is mounted.
In this window, you can remotely control the head amp of the I/O device from the CL series
console by using the on-screen knobs and buttons or the multifunction knobs.
2
3
4
5
6
1
+48V MASTER
Indicates the on/off status of the I/O device's master phantom power. (Switching this on
or off is performed on the I/O device itself.)
2
+48V button
These switch phantom power on/off for each channel.
3
GAIN knob
Indicates the gain of the head amp on the I/O device. To adjust the value, press the knob
to select it, and use the multifunction knobs. The level meter located at the immediate
right of the knob indicates the input level for the corresponding port.
4 GC button
Switches on or off the Gain Compensation function that maintains a consistent signal
level on the audio network.
5
FREQUENCY knob/HPF button
These controllers switch on or off the high-pass filter built into the head amp of the I/O
device, and adjust its cutoff frequency. If you press the FREQUENCY knob to select it,
you will be able to adjust it using the corresponding multifunction knob.
6
Displayed port switch tabs
These tabs switch the port that is displayed in the I/O DEVICE HA window.
7
GC ALL ON button/GC ALL OFF button
Switch Gain Compensation on or off for all input channels simultaneously.
8
GC indicator
Indicates the fixed gain value output to the audio network if the Gain Compensation
function is turned on.
158
I/O devices and external head amps
7
1
8
Reference Manual