Table 4-6. Cmm Network Page Controls - Supermicro MicroBlade User Manual

Control
Item
Name
1 MAC Address
2 Hostname
Automatic or
Manual IP
3
Address
Controls
IPv4 Setting
4
Controls
IPv6 Setting
5
Controls
6 VLAN Controls
7 RMCP Port
Network Link
8
Status
9 Save Button

Table 4-6. CMM Network Page Controls

Description
When you specify the IP Address manually, use this field to specify your MAC
Address. If you have chosen to have your IP address automatically
determined, then this control is greyed-out and cannot be modified.
Use this field to specify your Hostname.
Use these two option buttons to either O
( DHCP ) or U
USING MODE
to either automatically or manually specify an IP address for the network.
Use these controls specify your IP A
and DNS S IP. If you have chosen to have your IP address automatically
ERVER
determined, then these fields are greyed-out and cannot be modified except
for DNS S IP address.
ERVER
Use these controls to do the following: set IP
use A C
UTO ONFIGURATION
S modes, specify your DNS S
TATEFUL
Use these controls to E
Use this field to specify your RMCP port number.
This section shows your network link status for Active Interface, Status, Speed
and Duplex.
Once you are done configuring your network settings, press this button to
save your configurations.
BTAIN AN
IP
SE THE FOLLOWING
, S
DDRESS
V
, select either DHCP
IP or specify your DUID.
ERVER
or D VLAN or specify the VLAN ID.
NABLE ISABLE
4-11
Chapter 4: Configuration
IP
ADDRESS AUTOMATICALLY
( S
ADDRESSES USE TATIC MODE
M , G
UBNET ASK ATEWAY
6 A , A IP, D
DDRESS DD
6 S or DHCP
V TATELESS
)
address
IP,
ELETE
6
V