Alerts Page; Figure 4-1. Blade Status Page; Table 4-1. Blade Status Page Controls - Supermicro MicroBlade User Manual

Web-based Management Utility User's Manual
4-1

Alerts Page

Click on A
LERTS
for your system. The commands you may give on this page, are described below in
Table 4-1.
1
2
To setup an alert or to modify an alert setting, do the following.
1. Select an alert entry from the list presented on the page.
2. Click M
ODIFY
3. Click S
END
4. Click D
ELETE
Item Control Name
1 Alert List
2 Modify Button
Send Test Alert
3
Button
4 Delete Button
to reveal the A
LERTS

Figure 4-1. Blade Status Page

3 4
to configure or modify the settings of an alert.
T A to check if the alerts have been set and sent out correctly.
EST LERT
if you need to delete an alert.

Table 4-1. Blade Status Page Controls

Description
This table shows the currently active alerts, their number, their alert level
and their destination address. Select from this list in order to modify an
alert.
Press this button after selecting an alert from the table brings up the
M A
ODIFY LERT
this new page select the Event Severity, Destination IP, Email Address,
Subject and Message from the drop-down lists provided and press the
S button. If yo wish to cancel the alert, press the C
AVE
Press this button to send a test alert to its specified destination after you
have modified the alert.
Press this button to delete an alert from the list.
page (Figure 4-1). Use this page to set up alerts
page (Figure 4-2), which you use to modify an alert. In
4-2
button.
ANCEL