Switch Module Page; Table 2-11. Switch Module Page Controls - Supermicro MicroBlade User Manual

2-4

Switch Module Page

Click on S
WITCH
can use the commands listed in
To perform a function, first click the box(es) next to the power supplies you wish to issue
a command to and then click the command icon you wish to use. You can also click on
any of the individual power supplies listed to bring up additional pages with details about
that particular power supply's status, and the controls for setting them (see
Module Status Page" on page
1
Item Name
1 HW Reset Button
2 UID On Button
3 UID Off Button
4 Refresh Button
5 UID Button
NOTE: Initially, you must manually enter the IP address for each switch to gain access to it.
Each IP address should be unique when there are multiple switches on the same network
segment.
M to reveal the S
ODULE
Table 2-11
2-18).
Figure 2-15. Switch Module Page
2 3 4

Table 2-11. Switch Module Page Controls

Description
Press this button to reset a selected switch to its default configuration.
The reset button will reset all switch configurations, including IP address
and so on.
Press this button to turn on a UID for a selected switch.
Press this button to turn off a UID for a selected switch.
Click this icon to refresh the page and update the status of a switch
shown.
Press this button in the UID column to turn on or off a UID for a selected
switch.
M S
WITCH ODULE TATUS
to control the power supplies in your system.
5
2-17
Chapter 2: Blade System
page (Figure 2-15). You
"Switch