Switch Module Status - Fru Information Page; Figure 2-17. Switch Module Page - Fru Information Pane; Table 2-12. Switch Module Page - Summary Pane Controls - Supermicro MicroBlade User Manual

Table 2-12. Switch Module Page – Summary Pane Controls
Item Name
1 HW Reset Button
2 UID On Button
3 UID Off Button
4 Refresh Button
Configure Date and
5
Time Settings Section
Switch Network
6
Configuration Section
Switch Username and
7 Password Reset
Section
Reset to Factory
8
Default
Switch Module Status – FRU Information Page
Clicking on the FRU I
with static FRU information about the switch module selected.
Figure 2-17. Switch Module Page – FRU Information Pane
Description
Press this button to reset a selected switch to its default configuration.
The reset button will reset all switch configurations, including IP address
and so on.
Press this button to turn on a UID for a selected switch.
Press this button to turn off a UID for a selected switch.
Pressing this button refreshes the page display.
Use this section to configure the date and time settings for your selected
switch. Enter the time and date settings in the field provided and then
press the S button.
AVE
Use this section to configure the selected switches IP addresses (IP,
Subnet Mask and Gateway addresses). You may either do this manually
using static mode or do it automatically by using DCHP mode according
to the selection you make in the drop down list box provided. When
finished press the S
Use this section to enter the ADMIN password for the switch and confirm
it by entering the password in the fields provided. When finished press
the S button.
AVE
Press this button to reset the switch back to its factory default settings.
link brings up a FRU I
NFORMATION
2-19
Chapter 2: Blade System
button.
AVE
NFORMATION
pane ( )
Figure 2-17