System Installation - Casio MP-2000 Service Manual

4. System Installation

This Chapter describes the installation and the cable connection to the system connectors.
Sections of this chapter includes
* CPU
* DRAM
* HDD
* 4 X Serial Ports
* Parallel Port
* VGA
* Ethernet
* Drawer interface
* Keyboard
* PS/2Mouse
* External FDD
* Expansion Slot
* System O/S and Software Installation
The MP-2000 has a Pentium little board with a free PCI/ISA slot inside. It already builds in a Pentium CPU,
16MB of DRAM and a 2.5" HDD. These are all standard and the system is ready to play. Variety of the I/O
ports located at the back side of the chassis are available for customers to connect external peripheral devices,
such as a monitor, serial devices, parallel printer.. .etc. However, the interface specification of the peripherals are
vary depend on the manufactures and may not applicable to the MP-2000 POS system. Please confirm list of
the peripheral devices which are test by Casio as the MP-2000 POS system before you choose the peripherals.
Note: Since all specification and quality of the system are assured by Casio as the MP-2000 POS system, any
local modification of the CPU, DRAM, HDD, jumper setting on the motherboard or system components by cus-
tomer will not be applicable for Casio's guarantee or warranty unless modification are assured by Casio.
CPU
The MP-2000 system already builds in a designated CPU in the socked on the motherboard.
MP-2000: Intel MMX Pentium 233MHz on the motherboard SBC8352
To maintain the CPU, follow the instructions below.
1. To remove the existing CPU requires the use of a chip removing tool.
2. Locate pin 1 at the corner of the CPU socket and align the CPU's pin 1. Then place the CPU in the
socket. Check the notch on the corner of the CPU and the socket are properly aligned.
3. When a CPU is installed, the jumber settings on the motherboard are properly installed as factory
default for the MP-2000.
DRAM
The MP-2000 provides 2 x 72-pin SIMM sockets and 32 (16x2 ) MB of DRAM as standard. Maximum system
memory up to 128MB, respectively. To install the memory module, follow the instructions below and check the list
of DRAM memories tested as MP-2000.
1. Insert the memory module from the opening of the metal front compartment.
2. The memory module can only fit into the socket one way. Holding the memory module with the
notch on the upper right corner, then insert the memory module at a 45 degree angle and push the
module upright until it clicks into place.
The system is able to auto detect the new memory size automatically and it is not necessary to change the
system configuration after installation.
— 11 —