Casio MP-2000 Service Manual page 26

75 Hz
85 Hz
NOTE: 1.
2.
WINDOWS DEFAULT allows you to return to the default refresh rate setting for the selected monitor in Windows
95.
Setup Programs
The following setup programs were developed for the installation of CHIPS Display Drivers through Windows or
DOS. The driver files have been compressed wit the Microsoft Corporation ("MS") COMPRESS.EXE utility.
Please note that we do not support driver installation through the MS Windows Setup due to the limitations of
their COMPRESS.EXE and EXPAND.EXE utilities.
The setup programs contain video chip detection and video memory detection at the time of installation. These
programs will automatically detect the CHIPS VGA controller and the amount of video memory present in the
system, then read the appropriate script file, and then install the appropriate drives. For example, when setup
identifies the VGA controller and 512Kb video memory, the setup program will read the script files identified by
the characters "5K", and then install only the drivers that function with 512Kb of video memory.
English Environment
WINSETUP.EXE
WINSETUP.EXE is a setup program that allows the user to install driver files through Windows. This setup
program will expand driver files, and then install the drivers in the appropriate sub-directories. To install the
drivers, go to the Run command from the File menu in the Program Manager, and type A:\WINSETUP.
W*.INF
The W*.INF files are the script files for installation of the display drivers using WINSETUP.EXE. These files are
located in the root directory of Disk 3 and are required to be in the same directory as WINSETUP.EXE.
The W*.INF files may be edited by the OEM to tailor the WINSETUP.EXE program to install specific drivers.
These files may be modified by using any ASCII text editor. For example, if the OEM does not wish to install the
24bpp driver, W*.INF must be modified as follows:
Enter the W*.INF file into an ASCII text editor.
Go to the [Files] section of the W*.INF file.
Delete the line that contains the name of the file for the 24bpp driver.
Save the file and exit the text editor.
The W*.INF files may also be edited to install the drivers to another destination sub-directory. The default
destination sub-directory is \WINDOWS\SYSTEM. To change the destination sub-directory, replace "SYSTEM"
in the [Files] section of W*.INF with the destination sub-directory of your choice.
NOTE: Modifying other fields in the W*.INF file may cause WINSETUP.EXE to not function properly.
SETUP.EXE
SETUP.EXE is a setup program that allows the user to install driver files in DOS. This setup program will expand
driver files, and then install the drivers in the appropriate sub-directories. To install the drivers, type "SETUP" at
the DOS prompt.
The refresh rates that are supported by the selected monitor are the only refresh rates
that will show and be selectable.
The above Refresh Rates may not be supported by all CHIPS products.
— 25 —