Casio MP-2000 Service Manual page 27

Electronic cash register
Table of Contents

Advertisement

[Ethernet]
Introduction
The MP-2000 is equipped with an NE2000 compatible high performance Ethernet interface.
Setup and Diagnostic Test
Following software are provided in the floppy disk (Disk 4) for setup and test the Ethernet system.
The Setup Program
The MP-2000's Ethernet can be either set to PnP or non-PnP modes. In non-PnP mode, the configuration is
accompanied by the execution of the setup program, "SETUP.EXE". After passed a series of tests, the following
screen will appear:
UM9008 PnP Ethernet Controller Configuration & Diagnostic Program
Install drivers
Configuration
Diagnostics
AutoDetect
Accept & Exit
To change mode or configurations, please follow the instructions on the screen.
Install drivers
This menu is not available for the MP-2000. Please refer Installing Network Driver in this manual.
Configuration
Highlight "Configuration" option and press <ENTER>, a list of options including "Hardware configuration" , "Modify
Configuration" and "Quit" will appear.
Hardware configuration
The IRQ and I/O Base Address will appear after selecting this option. You can view the settings
and modify select the IRQ and I/O Base Address by " Modify configuration ".
Modify configuration
Highlight this option, and press <ENTER>, you can configure the settings of the onboard Ethernet.
A range of options is offered for IRQ, I/O and Boot ROM settings.
Diagnostic Test
The Diagnostic Test is a sub-function of SETUP.EXE. This diagnostic program tests all functions of MP-2000
Ethernet module and verifies its communication with another system on the network.
Copyright (c) reserved by UMC, 1996. V1.03 (03/2196)
— 26 —
Program Find UM9008 PnP NIC's Status
CARD 1(48 54 33 01 34 C1): IOBase-300, IRQ-2
Test Result ....................... Success

Advertisement

Table of Contents
loading

Table of Contents