Macaddresselseuserloginsecure Configuration Example - HPE FlexNetwork 7500 Series Security Configuration Manual

Aging type
Max secure MAC addresses
Current secure MAC addresses
Authorization
NAS-ID profile
# Display information about the online 802.1X user to verify 802.1X configuration.
[Device] display dot1x
# Verify that the port also allows one user whose MAC address has an OUI among the specified
OUIs to pass authentication.
[Device] display mac-address interface gigabitethernet 1/0/1
MAC Address
1234-0300-0011

macAddressElseUserLoginSecure configuration example

Network requirements
As shown in
authenticates the client by a RADIUS server in ISP domain sun. If the authentication succeeds, the
client is authorized to access the Internet.
Configure GigabitEthernet 1/0/1 of the device to meet the following requirements:
•
Allow more than one MAC authenticated user to log on.
•
For 802.1X users, perform MAC authentication first and then, if MAC authentication fails,
802.1X authentication. Allow only one 802.1X user to log on.
•
Use the MAC address of each user as the username and password for authentication. A MAC
address is in the hexadecimal notation with hyphens, and letters are in upper case.
•
Set the total number of MAC authenticated users and 802.1X authenticated users to 64.
•
Enable NTK (ntkonly mode) to prevent frames from being sent to unknown MAC addresses.
Figure 77 Network diagram
Host
Configuration procedure
Make sure the host and the RADIUS server can reach each other.
1. Configure RADIUS authentication/accounting and ISP domain settings. (See
"userLoginWithOUI configuration
2. Configure port security:
# Enable port security.
<Device> system-view
[Device] port-security enable
VLAN ID State
1 Learned
Figure 77, a client is connected to the device through GigabitEthernet 1/0/1. The device
Authentication servers
(192.168.1.2/24
192.168.1.3/24)
GE1/0/1
Device
: Periodical
: Not configured
: 1
:Permitted
: Not configured
Port/NickName
GE1/0/1
Internet
example.")
240
Aging
Y