Publickey Authentication Enabled Stelnet Server Configuration Example - HPE FlexNetwork 7500 Series Security Configuration Manual

To establish a connection to the Stelnet server:
a. Launch PuTTY.exe to enter the interface shown in
b. In the Host Name (or IP address) field, enter the IP address 192.168.1.40 of the Stelnet
server.
Figure 90 Specifying the host name (or IP address)
c. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username and
password. After entering the username (client001 in this example) and password (aabbcc in
this example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in
the RSA public key algorithm.
Establish an Stelnet connection between the host and the switch, so that you can log in to the switch
to configure and manage the switch.
Figure 91, the switch acts as the Stelnet server, and it uses publickey authentication and
Figure
333
90.