•
The ports at the ends of the link are MACsec capable.
Analysis
The symptom might occur for the following reasons:
•
The ports at the link are not enabled with MKA.
•
A port at the link is not configured with a preshared key or configured with a preshared key
different from the peer.
Solution
To resolve the problem:
1.
Enter interface view.
2.
Use the display this command to check the MACsec configuration:
If MKA is not enabled on the port, execute the mka enable command.
If a preshared key is not configured or the preshared key is different from the peer, use the
mka psk command to configure a preshared key. Make sure the preshared key is the same
as the preshared key on the peer.
3.
If the problem persists, contact Hewlett Packard Enterprise Support.
495